At times it is easy to know when to call Told Plumbing. A yearly maintenance call may revile a problem before you get water all over, or wake up to a cold house.
By simply cleaning the boiler aned adjusting the gas pressure to manufacturers specs you can reduce your gas bill. We can help you in your existing home. Enjoy warm floors, finish your basement, add heat to a cold area, or heat an addition off of your existing water heater.
Ask how to get all the domestic hot water you need from your boiler:
Cold Spots- If you have an area in your house that is cold, when the rest of the area using the same thermostat, the solution is typically to bleed the air out of the system.
Cold Everywhere- When the entire area being monitored by a thermostat is cold, the problem is most likely a zone valve or a pump problem.
Noisy Pump- Needs oil, bad bearings, rust build up in the volute.
Clean Boiler- Cleaning the boiler on a regular basis will help the boiler run more efficiently. Many boilers are equipped with roll out sensors searching for exhaust and flame roll out caused by a dirty heat exchanger.
Electrical Problems- From shorts to burnt fuses, electrical problems can be tricky to find. They are normally easy to fix once they are located.
No Water Pressure- Most boilers are equipped with an automatic fill valve, on occasion these valves can stick, and in some cases many need replaced.
Relief is Leaking- This is a symptom of a bad expansion tank problem. In most cases this requires changing the expansion tank. When the boiler relief has leaked it is a good practice to change the relief to ensure it does not continue to leak.
What about the Questar Green Sticker:
 By asking to have a green sticker check for your appliances, you will ensure the correct amount of gas is sent to your appliance. This gives you a clean, safe flame.
|
